ISA Floppy Disk and Serial Controller

From docs
Revision as of 21:16, 20 September 2021 by Numberformat (talk | contribs)
Jump to navigation Jump to search

This is a place holder page for the ISA Floppy Disk and Serial Controller

Floppy-controller-assembled.jpg

Board Assembly

Install the shorter components first this means installing them in the following order

  • 24 Mhz Crystal
  • Capacitors, resistor arrays
  • DIP Sockets
  • DIP Switches
  • Square sockets
  • Floppy connector
  • 9 pin serial header

DIP Switch settings

A good starting point is to set the dip switch 2 and 8 ON. This will put Serial port on IRQ 4. and base address 0x3F8 (COM1).

Note: Only one of SW1.1 - SW1.4 should be ON. All switches can be off if software doesn't use interrupt based I/O. Note: One and only one of SW1.5 - SW1.8 switches should be ON.

For the ROM Address you can switch all of SW3 ON except 5 and 8. This will put the floppy controller ROM at address 0xE8000.

Note: If you are using the XT-CF or similar card then the floppy controller needs to be at a higher address.

See the original designer's website for detailed configuration of the DIP switches.

Troubleshooting

The floppy drive works but the C drive is not detected.

This can happen if you have both the XT-IDE and floppy ROM Extensions installed on the same system where the XT-IDE is at a higher address. You will notice that the usual XT-IDE boot screen will not show. In this case make sure the floppy controller address is higher than the XT-IDE.

For example the floppy controller is at 0xC8000(lower) and the IDE controller is at 0xCA0000 (higher) then swap the addresses by adjusting the DIP switches.

Retrieved from "http://wiki.noami.us/index.php?title=ISA_Floppy_Disk_and_Serial_Controller&oldid=234"